Loading ...
Loading ...
Loading ...
W415-2835 / B / 04.05.21
EN
44
electrical information
5.2 battery back-up installation
A. Remove the safety barrier by lifting it up and off of the four shoulder screws.
B. Locate your battery holder, this would have been supplied in the manual baggie.
C. Locate the red and black wires from the control module to connect to the battery holder, as shown below.
D. Connect the red wire from the control module to the red wire of the battery back-up. Ensure the protective
sleeve covers the connections, as shown below.
E. Connect the black wire from the control module to the black wire of the battery back-up. Ensure the
protective sleeve covers the connections, as shown below.
F. Install 4 “AA” size batteries, ensure the positive and negative ends correspond with those identifi ed on the
holder.
G. Place the battery holder either onto the hearth, or in the front left corner of the control area, for the
duration of the power failure, as shown below.
H. Ensure the safety barrier is reinstalled onto the appliance during operation.
Red wire
Black wire
Battery housing
Control module
In the event of a power failure, your appliance can be operated using the battery back-up supplied.
note:
Once the power has been restored, you should disconnect the battery back-up or remove the
batteries from the holder.
note:
• Ensure the gas and electrical power to the appliance is turned off.
• Appliance may be hot. Do not service until the appliance has cooled.
!
WARNING
Loading ...
Loading ...
Loading ...