Napoleon GSS48ST OUTDOOR GAS FIREPLACE

User Manual - Page 28

For GSS48ST. Also, The document are for others Napoleon models: GSS48

PDF File Manual, 40 pages, Read Online | Download pdf file

GSS48ST photo
Loading ...
Loading ...
Loading ...
28
www.napoleon.com
N415-0346-AU FEB 23.21
Burner: The burner is made from heavy wall 304 stainless steel, but extreme heat and a corrosive
environment can cause surface corrosion to occur. This can be removed with a brass wire brush. Inspect
the burner at least annually for cracks, insect nests, excessive corrosion or any other damage. If the
burner is damaged, it must be replaced with a burner specied by the manufacturer before the appliance
is put into operaon.
CAUTION! Beware of Spiders.
Spiders and insects are aracted to the smell of propane and natural gas. The burner is equipped with an
insect screen on the air shuer, which reduces the likelihood of insects building nests inside the burner
but does not enrely eliminate the problem. A nest or web can cause the burner to burn with a so
yellow or orange ame or cause a re (ashback) at the air shuer underneath the control panel. Other
warning signs that may indicate a problem are:
Strong or unusual odor coming from the appliance.
Connued diculty or delayed ignion.
Flame appears either very short or very long.
Flame only burns part way across the burner.
Excessive soot building up on the glass embers.
To clean the inside of the burner, it must be removed from the appliance: Remove the front glass shield
and the glass embers and examine the burner. If dirty, clean with a wire brush. Remove the screws that
aach the glass ember tray and the wind shield.
Cleaning: Use a exible venturi tube brush to clean the inside of the burner. Shake any loose debris from
the burner through the gas inlet. Check the burner ports and valve orices for blockages. Burner ports can
close over me due to debris and corrosion, use an opened paperclip or a drill bit to clean them The ports
are easier to clean if the burner is removed from the appliance, but it can also be done with the burner
installed.
Li the glass tray from the replace, pushing from the top, disengage the thermocouple and igniter from
the glass tray.
Remove the ex hose and the orice from the burner and completely remove the glass tray from the
replace.
Loading ...
Loading ...
Loading ...