Loading ...
Loading ...
Loading ...
Scope of Delivery
A Class HP Installation a
nd User Instructions R02583
-6 09/15
Page
7
Precaution: This appliance can be
used by children aged from 8 years and
above and persons with reduced
physical, sensory or mental capabilities
or lack of experience and knowledge if
they have been given supervision or
instruction concerning use of the
appliance in a safe way and
understanding the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Note: Between the inlet group and
the cold water inlet on the cylinder
NO isolating device may be fitted,
as by doing so important safety
devices could be isolated!
It is important to check the pre-
charge pressure of the expansion
vessel membrane before filling the
cylinder. This has been factory set
to 3 bar. The pre-charge should be
greater than or equal to 3 bar.
It is important that the tundish is
positioned away from any
electrical components.
Note: Means for electrical
disconnection must be incorporated
in the fixed wiring in accordance
with the wiring rules.
Before removing the cover from
the immersion heater isolate
appliance using isolating switch!
Danger of electrical shock! Only
use suitable electrically insulated
equipment when working inside
immersion housing.
The maintenance of this
appliance must be carried out by
a suitably qualified person only.
It is recommended to maintain
the unit on an annual basis.
Isolate all electrical supplies
from the unit before
commencing work. Danger of
electrical shock!
CLEANING INSTRUCTIONS:
Clean outer cladding of cylinder
with a soft cloth dampened with
warm water only. Do not use
abrasive or aggressive cleaning
materials, such as alcohol or
petroleum based solvents, as
this may damage the surface of
the product.
Temperature setting: A high level
cutout is fitted to the product for
each heat source. This should never
activate under normal operation.
The maximum possible cylinder
temperature attainable by the heat
pump is 65°C as set on the User
Interface. The back-up immersion
heater can produce up to 72°C at
its maximum setting, i.e. 5. For
convenience the immersion heater
is preset to produce 60°C.
If an electronic copy of this manual
should be required, please contact the
manufacturer at the address at the
back of this manual.
Loading ...
Loading ...
Loading ...