Loading ...
Loading ...
Loading ...
5. Flex Zone
- To remove the Flex Zone : Pull the Flex door
out to full extension. Lift the Flex Zone up,
pulling it to your body with both hands.
- To re-install the Flex Zone : Open the Flex
door to full extension.
Tilt the front of the Flex Zone up, place the
back of the Flex Zone onto the rails, and then
lower the front until the whole Zone rests on
the rails.
When the Flex Zone or LED lighting is not
working, check the connectors [ (1), (2)
shown below ] for cracks or leaks.
(2)
(1)
1. Refer to page 21 for disassembly
instructions.
2. Open the cap cover rail with a flat-blade screw
driver.
Using the doors
Ensure that the doors close all the way and are
securely sealed.
When the refrigerator door is only partially open, it
will automatically close.
If the the door is opened more than its auto close
range, it will remain open.
You must close it manually.
REMOVING THE FREEZER
ACCESSORIES
1. Freezer Room Guard
- To remove : Remove the freezer room guard
(1) by lifting the guard up.
- To re-install : Push down until the guard (1)
locks into place.
(1)
2. Super Extended Drawer
- To remove : Pull the drawer out to full
extension. Tilt up the rear of the drawer and lift
straight out.
- To re-install : Place the drawer onto the rails
(4) by tilting it up.
Lower the drawer into place until it is horizontal
and slide the Drawer (3) in.
3
4
English - 51
OPERATING
DA68-03022B (EN)-04.indd 51 14. 6. 23. �� 2:48
Loading ...
Loading ...
Loading ...