Loading ...
Loading ...
Loading ...
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
In order for the ice maker to operate properly, a
water pressure of 138 ~ 862kPa is required.
Under normal conditions, a 170cc (5.75oz.) cup
can be filled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure (below 138kPa), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until
the water runs from the water outlet.
Water line installation kits are include with
unit. You can find it in freezer drawer.
The new hose-sets supplied with the
appliance are to be used and that old
hose-sets should not be reused.
Parts for water line Installation
Water line fixer and screws Pipe connector
Water line
Connecting to the water supply line
1. First, shut o the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected to the
cold water pipe.
If it is connected to the hot water pipe, it
may cause the purifier to malfunction.
Close Main Water
pipe
Close Main
Water pipe
No gap
4. After connecting the water supply to the water
filter, turn your main water supply back on and
dispense about 3L to clear and prime the
water filter.
English - 25
SETTING UP
DA68-03022B (EN)-04.indd 25 14. 6. 23. �� 2:47
Loading ...
Loading ...
Loading ...