Loading ...
Loading ...
Loading ...
20
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time.
Be sure the Auto Input Search function in the SYSTEM SETUP: BASIC menu is On if
you want the projector to automatically search for the signals.
You can also manually select the desired signal by pressing one of the source selection keys
on the remote control, or cycle through the available input signals.
1. Press Source. A source selection bar is displayed.
2. Press / until your desired signal is selected and press Enter.
Once detected, the selected source information will be displayed on the screen for
seconds. If there are multiple devices connected to the projector, repeat steps 1-2 to
search for another signal.
Please see "Projector specifications" on page 51 for the native display resolution of this
projector. For best display picture results, you should select and use an input signal which
outputs at this resolution. Any other resolutions will be scaled by the projector depending
upon the 'aspect ratio' setting, which may cause some image distortion or loss of picture
clarity. See "Selecting the aspect ratio" on page 21 for details.
Changing HDMI input settings
In the unlikely event that you connect the projector to a device (like a DVD or Blu-ray
player) via the projector’s HDMI input and the projected picture displays wrong colors,
please change the color space to an appropriate one that fits the color space setting of the
output device.
To do this:
1. Open the OSD menu and go to the SYSTEM SETUP: ADVANCED > HDMI
Range menu.
2. Press / to select a suitable color space according to the color space setting of the
output device connected.
• Auto: Sets the projector to detect the HDMI range of the input signal
automatically.
• Full Range: Sets the HDMI color range as 0 - 255.
• Limited Range: Sets the HDMI color range as 16 - 235.
This function is only available when the HDMI input port is in use.
Refer to the documentation of the device for information on the color space and HDMI range
settings.
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 2 adjuster feet. It changes the image height and vertical
projection angle. Screw the adjuster feet to fine tune the angle until the image is positioned
where you want it.
Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes.
Loading ...
Loading ...
Loading ...