Loading ...
Loading ...
Loading ...
107
Synchronizing with an External Device
• When the camera locks on an external time code signal, [E] will appear next to the time code on the control
display and at the bottom right corner of the monitoring screen.
• If the external time code signal is incorrect or there is no input signal, the internal time code set in the camera
will be recorded instead.
• While a DF time code signal is being received, the external time code’s drop-frame bit will be used.
• Performing any of the following actions while the cable is not connected will cause the synchronization to be
disrupted; the correct time code will be restored once you reconnect the cable.
- Turning the camera off or pressing the PLAY button (switching to playback mode)
- Changing the video configuration
Reference Video Signal Output
You can output the camera’s video signal as a reference sync signal (tri-level HD signal) to synchronize an
external device to this camera. The reference video signal output will have the same frequency as the signal
output from the SDI OUT terminals.
1 Open the GENLOCK/SYNC OUT terminal’s [Terminal Function] submenu.
[System Setup] (
B
) > [GENLOCK/SYNC OUT] > [Terminal Function]
2 Select [HD Sync Output] and then press SET.
• If necessary, change the scan mode (P or PsF) with the [SYNC Scan Mode] setting in the same submenu.
Synchronization signals
* When slow & fast motion recording is activated, the signal output will change depending on the system frequency used:
1080/59.94i (59.94 Hz), 1080/50.00i (50.00 Hz) or 1080/60.00i (24.00 Hz). When slow & fast motion recording is activated while
[Camera Setup] > [Sensor Mode] is set to [Super 16mm (Cropped)], the signal output will always be 1080/60.00i.
Time Code Signal Output
The time code will be output from the TIME CODE IN/OUT terminal as a SMPTE-standard LTC timing signal. The
user bit will also be output. Additionally, the time code will be output from the SDI OUT terminals and MON.
terminals.
Before connecting the external device, set [OPTIONS] > [TC In/Out] to [Out] to change the TIME CODE
terminal’s function to output (A 106).
NOTES
NOTES
• The time code will not be output when slow & fast motion recording is activated or during playback.
Video output from the SDI OUT terminals
Signal output from the SYNC OUT
terminal (tri-level HD signal)
Resolution Frame rate
4096x2160
3840x2160
2048x1080
1920x1080
29.97P 1080/29.97 (P/PsF)
25.00P 1080/25.00 (P/PsF)
24.00P 1080/24.00 (P/PsF)*
23.98P 1080/23.98 (P/PsF)
4096x2160
3840x2160
2048x1080
1920x1080
59.94i / 59.94P 1080/59.94i
50.00i / 50.00P 1080/50.00i
Loading ...
Loading ...
Loading ...