Loading ...
Loading ...
Loading ...
3
Preparing the Dishwasher for Use
Unpacking the Dishwasher
Use at least two people to move and install the dishwasher to prevent back and other types of
injuries. Carefully remove the packaging materials. Remove any shipping tape and glue from
your dishwasher before using. Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of
your dishwasher. Check to make sure the parts necessary for installation are included. If any
parts are missing, please contact our customer service. Put the dishwasher on a level and flat
surface that is able to support the entire weight of the dishwasher fully loaded.
Installation Requirements
The dishwasher has been designed for a countertop installation. Please follow the instructions
for clearance, water, and electrical requirements.
Clearance Requirements
The minimum height clearance required to install your dishwasher on a counter top surface
with overhead cupboards is 17-¾” (45cm).
Water Requirements
Make sure the water supply/faucet connection is within reach of the inlet and drain hose
assembly (i.e. 22-¾” / 58 cm). If your sink has a spray wand, it is recommended that the hose
be disconnected and the hole plugged.
Water Pressure
For best results, incoming water pressure should be between 15 and 20 pounds per square
inch (psi).
Water Temperature
For best results, the water temperature must be at least 120ºF (49ºC). To prevent damage to
the dishwasher, the temperature of the incoming water supply should not exceed 140ºF
(60ºC).
Caution: A hose that attaches to a spray wand can burst if it is installed on the same water line
as the dishwasher.
Loading ...
Loading ...
Loading ...