User Manual - Page 117

For MII 2014.

Loading ...
Loading ...
Loading ...
Driver assistance systems
WARNING
If you do not start the vehicle immediately
after taking your foot off the brake pedal, the
vehicle may start to roll back under certain
conditions. Depress the brake pedal or use
the hand brake immediately.
If the engine stalls, depress the brake ped-
al or use the hand brake immediately.
When following a line of traffic uphill, if you
want to prevent the vehicle from rolling back
accidentally when starting off, hold the brake
pedal down for a few seconds before starting
off.
Note
The Official Service or a specialist workshop
can tell you if your vehicle is equipped with
this system.
Start-Stop system
Warning lamps
It
lights
up
Possible cause Solution
The Start-Stop system
is enabled.
It
lights
up
Possible cause Solution
The Start-Stop system
is enabled but the en-
gine cannot be auto-
matically stopped.
Contact a special-
ised workshop.
The Start-Stop system
cannot start the en-
gine.
Start the engine by
hand using the ve-
hicle's key
page 86.
There is a fault in the
alternator.
page 154
Flash-
es
Possible cause Solution
The Start-Stop system
is not available.
Contact a special-
ised workshop.
Some warning and control lamps will light up
briefly when the ignition is switched on to
check certain functions. They will switch off
after a few seconds.
WARNING
Observe the safety warnings ›› in Control
and warning lamps on page 40.
Start-Stop system
Fig. 93 At the top of the centre console: Start-
Stop system button
With the Start-Stop system enabled, the en-
gine is automatically stopped when the vehi-
cle is at a standstill. It will start again auto-
matically as required.
This function remains enabled while the igni-
tion is switched on. The instrument panel dis-
play shows information on the current status
page 115
.
Di
s
connect the Start-Stop system by hand
whenever crossing water.
Vehicles with a manual gearbox
When the vehicle is stopped, put it into
neutral and release the clutch pedal. The en-
gine will stop.
To restart, simply engage the clutch.
»
115
Technical specifications
AdviceOperationSafety
Loading ...
Loading ...
Loading ...