Loading ...
Loading ...
Loading ...
Faults and what to do about them en
51
The water is not draining. ■ Could the drain pump be blocked?
~ "Drain pump is blocked" on page 47
■ Could the drain hose at the siphon be blocked?
~ "The drain hose at the siphon is blocked" on page 47
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
■ Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed. Distribute small and
large items of laundry evenly in the drum.
■ Is Easy iron additional programme setting selected? (depending on the
model)
■ Is Silent wash additional programme setting or Silent wash programme
selected? (depending on the model)
■ Is the selected speed too low?
The spin cycle runs sev-
eral times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
■ Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly distributing the laundry.
■ Not a fault – the foam detection system is active – a rinse cycle has been
switched on.
The length of the pro-
gramme changes during
the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the Touch-
Display.
Foam may come out of
the detergent drawer.
Too much detergent used?
Reduce the basic dosage of ß i-Dos for the next washing cycle with the same
load.
Use commercially available low foam detergent and care product which are
suitable for machine.
Residual water in the left-
hand compartment for
the care product.
Not a fault – the effectiveness of the care product is not affected.
Odours, stain formation in
the appliance.
Run the ä Drum Clean 90 °C programme without laundry.
Add washing powder or a detergent containing bleach.
Note: To prevent foaming, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use detergents designed for woollens or
delicates.
Repeated, intensive foam-
ing.
■ Check your basic dosage and dosage strength settings.
■ If required, use a different liquid detergent.
Faults Cause/Remedy
Loading ...
Loading ...
Loading ...