Loading ...
Loading ...
Loading ...
Intelligent dosing system en
35
Everyday use
Displays:
■ The display lights up if intelligent
dosage has been selected for the
dispenser.
■ The display for the adjustment
values, e.g. Y flashes if the fill level
for the dispenser is below the
minimum level when intelligent
dosing has been selected.
(De)selecting intelligent dosage and
adjusting the dosage strength:
The intelligent dosages for detergent
and fabric softener are set at the factory
for all programmes in which intelligent
dosing can be used.
The dosage strength has been preset to
X (lightly soiled laundry) for detergent ß
and to Y (medium level of softness) for
fabric softener M. It can be changed
individually for each programme.
In addition to intelligent dosing, washing
additives (e.g. stain remover) can be
added manually via the left-hand
compartment.
Note: The selection (on/off) and the
selected dosage strength for
ß i-Dos and M i-Dos are saved for
each programme until they are changed
again, even if the appliance is switched
off.
Topping up the detergent/ fabric
softener:
If the display for the selected intelligent
dosing flashes, this means that the
amount of detergent or fabric softener in
the dispenser is below the minimum fill
level. The content is sufficient for
approx. three washes.
The same detergent or fabric softener
can be added at any time. If you change
product/manufacturer, we recommend
that you clean the dispensers first.
If required, adjust the basic dosage.
Basic settings
The basic dosages are:
■ For detergents – based on the
manufacturer’s recommendation for
average soiling and the respective
water hardness.
■ F or fabric softeners – based on the
manufacturer's recommendation for
a medium level of softness.
Refer to the packaging label on your
detergent/fabric softener or ask the
manufacturer directly for this
information.
To find out the hardness of your water
supply, use a test strip or check with
your water supplier.
My water hardness:
Loading ...
Loading ...
Loading ...