Dodge 2017 GRAND CARAVAN User Manual

Loading ...

It may be helpful to unplug the device during the cycling

process to prevent possible overheating of the garage door

or gate motor.

1. Cycle the ignition to the ON/RUN position.

NOTE: For vehicles equipped with Keyless Enter-N-Go,

place the ignition in the RUN position with the engine ON.

Make sure while programming HomeLink with the engine

ON that your vehicle is outside of your garage, or that the

garage door remains open at all times.

2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)

away from the HomeLink button you wish to program

while keeping the HomeLink indicator light in view.

3. Continue to push and hold the HomeLink button while

you push and release (“cycle”) your hand-held trans-

mitter every two seconds until HomeLink has success-

fully accepted the frequency signal. The indicator light

will flash slowly and then rapidly when fully trained.

4. Watch for the HomeLink indicator to change flash rates.

When it changes, it is programmed. It may take up to 30

seconds or longer in rare cases. The garage door may

open and close while you are programming.

5. Push and hold the programmed HomeLink button and

observe the indicator light.

NOTE:

• If the indicator light stays on constantly, programming

is complete and the garage door/device should acti-

vate when the HomeLink button is pushed.

• To program the two remaining HomeLink buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

If you unplugged the garage door opener/device for

programming, plug it back in at this time.

Reprogramming A Single HomeLink Button

(Canadian/Gate Operator)

To reprogram a channel that has been previously trained,

follow these steps: