Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
36
3. Controls
3.1 To Replace the Light Switch
Disconnect from electricity supply.
Remove the control panel (see
1.1).
Note: The old switch may be destroyed during removal.
Remove the old switch from its bezel by gripping the switch
body behind the control panel and twisting sharply. Remove
the switch bezel by folding back its locking wings and pushing
forward. Fit the new bezel to the control panel by rst lining
up the raised key on its body with the cut-out in the control
panel and pushing it in from the front.
Assemble the new switch to the bezel by lining up the key
sections and pushing home. Fit the new button by pushing in
from the front. Replace the Control Panel in reverse order and
test for correct operation.
3.2 To Remove the Electronic Timer
Disconnect from electricity supply.
Remove the control panel (see
1.1). Pull o the timer control
button(s).
Remove the timer/mounting bracket assembly from the
control panel by removing the xing screws.
Remove the timer from its mounting bracket by depressing
the plastic lugs on the timer case, at the same time pulling the
unit forward. Reassemble in reverse order. When replacing the
leads, refer to the wiring diagram in this manual. Check the
operation of the timer.
4. Grill
4.1 To Replace the Grill Controller
Disconnect from electricity supply.
Lift up the hob and remove the control panel (see
1.1 and
2.1). Disconnect the wiring from the controller. Remove the
two screws holding the controller to the mounting panel. Fit
the new controller and reassemble in reverse order. Check for
correct operation.
4.2 To Remove a Grill Element
Disconnect from electricity supply.
Remove the grill pan from the grill compartment. Undo the
two screws and washers in the grill roof and remove the
enamelled front shield.
Undo the 2 screws and washers securing the grill element
front support. Remove the screws from the grill elements.
Lift the elements out carefully and, noting their position,
disconnect the leads from the element terminals.
If it is not possible to disconnect the leads in this way, pull the
cooker forward to gain access to the rear. Undo the screws
securing the electric cover to the back sheet and remove
the cover. Disconnect the terminals from the rear. Fit new
elements and reassemble in the reverse order. Check the
operation of the grill.
Loading ...
Loading ...
Loading ...