Loading ...
Loading ...
Loading ...
Closing without the jam protection
system
In case of danger from the outside or if ice
might prevent normal closing, proceed as
follows:
1. Pull the switch past the resistance
point and hold it there.
The window closes with limited jam pro-
tection. If the closing force exceeds a
specific threshold, closing is inter-
rupted.
2. Pull the switch past the resistance
point again within approx. 4 seconds
and hold it there.
The window closes without jam protec-
tion.
Malfunction
General information
In certain situations a window can only be
operated to a limited extent.
– After a power failure during the opening
or closing process, the a window can
only be operated to a limited extent. The
system must be initialized in this case.
– The power window motors are equipped
with overheating protection. If a win-
dow is opened and closed several times
within a short period of time, the over-
heating protection switches the motor
off temporarily. Depending on the de-
gree of overheating, it may only be pos-
sible to close the window or it may not
be possible to operate it at all.
In this case: allow the power window
motor to cool down.
Initializing the system
The system can be initialized when the ve-
hicle is stationary and the engine is run-
ning.
During initialization, the affected window
closes without jam protection.
Warning
When operating the windows, body parts
and objects can be jammed. There is a risk
of injury or risk of damage to property.
Make sure that the area of movement of
the windows is clear during opening and
closing.
1. Open the affected window completely.
2. Pull the switch to the resistance
point and hold.
The window closes.
3. Continue holding the switch pulled
to the resistance point.
The window opens and closes once or
twice after approx. 15 seconds, depend-
ing on the vehicle's equipment.
4. Release switch.
Seite 76
CONTROLS Opening and closing
76
Online Edition for Part no. 01405A02C45 - II/20
Loading ...
Loading ...
Loading ...