Loading ...
Loading ...
Loading ...
5. Remove the dipstick again and check the oil
level. It should be between the H and L marks
쎻
1
. If the oil level is below the L mark
쎻
2
,
remove the oil filler cap and pour recom-
mended oil through the opening. Do not
overfill
쎻
3
.
6. Recheck oil level with the dipstick.
It is normal to add some oil between oil
maintenance intervals or during the
break-in period, depending on the severity
of operating conditions.
CAUTION
Oil level should be checked regularly.
Operating the engine with an insuffi-
cient amount of oil can damage the
engine, and such damage is not covered
by warranty.
CHANGING ENGINE OIL AND
FILTER
Change the engine oil and filter according to the
maintenance log shown in the “NISSAN Service
and Maintenance Guide”.
Vehicle set-up
1. Park the vehicle on a level surface and apply
the parking brake.
2. Start the engine and let it idle until it reaches
the operating temperature.
3. Turn the engine off and wait more than 10
minutes.
4. Raise and support the vehicle using a suit-
able floor jack and safety jack stands.
쐌 Place the safety jack stands under the vehicle
jack-up points.
쐌 A suitable adapter should be attached to the
jack stand saddle.
5. Remove the plastic engine undercover.
a. Remove the small plastic clip at the center
point of the undercover.
b. Then remove the other bolts that hold the
undercover in place.
CAUTION
Make sure the correct lifting and sup-
port points are used to avoid vehicle
damage.
Engine oil and filter
1. Place a large drain pan under the drain plug
쎻
1
.
2. Remove the oil filler cap.
3. Remove the drain plug with a wrench and
completely drain the oil.
WARNING
쐌 Prolonged and repeated contact with
used engine oil may cause skin
cancer.
SDI2052
8-10 Maintenance and do-it-yourself
墌 08.7.24/Z33-D/V5.0 墍
Loading ...
Loading ...
Loading ...