Loading ...
Loading ...
Loading ...
installation instructions ......................................
PLACEMENT OF THE
%
REMOVING THE MICROWAVE
HOOD FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
[]Remove the installation instructions, adapter,
fiRe[s, glass tray and the small hardware bag. Do
not iemove the Styrofoam protecting the front of
[_] the microwave hood.
Fold back all 4 carton flaps fully against carton
sides, Then carefully roll the microwave hood
and carton over onto the top side., The microwave
hood should be resting in the Styrofoam,
[]Pull the carton up and off the microwave hood,
[_] Remove and properly discard plastic bags,
Mounting
Plate
!
[-_ Remove the 2 screws from the mounting plate,
This plate will be used as the rear wall template
and for mounting, You may discard these screws,
MOUNTING PLATE
_] FINDING THE WALL STUDS
[_ Find the studs, using one of the following
methods:
A. Stud finder - a magnetic device which
locates nails,.
OR
B, Use a hammer' to tap lightly across the
mounting surface to find a solid sound,
This will indicate a stud location,.
[_ After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of' the stud. ]?hen place a mark halfway between
the edges, "[he center of any adjacent studs should
be 16" or 24" from this mart<,
[_ Draw a line down the center of the studs_
THE MICROWAVE HOOD MUST BE
CONNECTED TO AT LEAST ONE WALL STUD.
8
Loading ...
Loading ...
Loading ...