Loading ...
Loading ...
Loading ...
Installation instructions
RECIRCULATING (Non-Vented Ductless)
INSTALLATION OVERVIEW
AI. Attach Mounting Plate to Wall
A2. Prepare Tbp Cabinet
A..3°Mount the Microwave Hood
A4° When Replacing the
Charcoal Filter
]
NOTE: The exhaust adapter
with damper is not needed fox
recirculating models,, You may
want to save them for possible
future use,
ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts,
At least one wood screw must be used to attach
the plate to a wall stud,
_ Remove the toggle wings from the bolts
[_ nsert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to 3Z1"onto each bolt,
To use toggle bolts:
Spacingfor Toggles
More ThanWall
Thickness
leWings
Plate:_
BoltEnd
iiiiiiii . i, i I .................. ii Jill
N lace the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate,,
NOTE= Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet,
O.UTION: Be carefu! to avoid pinching fingers
between the back of the mounting plate and the wall.
[_] Tighten all bolts_ Pull the plate away from the wall
to help tighten the bolts
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through,
L_
* Read the instructions on the TOP CABINET
rEMPLA:IE,.
* 1ape it underneath the top cabinet.
o Drill the holes, following the instructions on the
roP CABINEF TEMPLAIE
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom
................... ]
12
Loading ...
Loading ...
Loading ...