Loading ...
Loading ...
Loading ...
33
Transferring data by entry
To transfer an entry in a mode :
1. Display the entry to be transferred to the other Organizer on the
transmitting Organizer.
2. Set the receiving Organizer to the mode in which the transmitting
Organizer is entered.
3. Press
2nd
OPTION
on both the
Organizers.
The following OPTION menu is
displayed.
4. Press
2
on the receiving Organizer (to select “RECEIVE”).
5. Press
1
on the transferring Organizer (to select “SEND”).
6. Data transfer is started.
Messages are displayed on the respective Organizers while data is
being transferred. When these messages are no longer displayed,
the data transfer is completed.
To verify data while it is transferred, select
3
(VERIFY) on the
receiving Organizer in step 4.
Transferring data by mode
To transfer all data in a mode:
1. Enter the mode from which data is to be transferred to the other
Organizer on the transmitting Organizer.
Perform steps 2 to 6 described in “Transferring data by entry”.
NOTE: When the secret function is turned on, an error message is
displayed on the receiving or transmitting Organizer, or both the
Organizers. Be sure to turn off the secret function before transferring
data by mode.
< UNIT TO UNIT >
I/O DEVICE
ERROR !
• The indication “WORKING...” shown on the side of the receiving
Organizer at the beginning or end of the data transmission means
that the memory has begun to be freed up automatically.
• The indication “Replace the OPERATING batteries!” shown when
2nd
OPTION
are pressed means that the operating batteries are
almost exhausted. Replace them with new ones then try again to
transfer data.
Transferring data between Organizers
A single data entry or entire data in a mode (TEL1, 2, 3/SCHEDULE/
MEMO/TO DO/EXPENSE/ANN1, 2) can be transferred between
Organizers.
NOTES:
• Turn both of the Organizers off first before connecting them with the
SHARP-specific cable (CE-300L, optionally available).
< UNIT TO UNIT >
1:SEND 4:BACKUP
2:RECEIVE 5:RESTORE
3:VERIFY
1
2
3
• The following descriptions assume connections between the same
models.
• When an error occurs, the following error
message is displayed on the receiving or
transmitting unit, or both the units.
Loading ...
Loading ...
Loading ...