Loading ...
Loading ...
Loading ...
19
FILTER
Performance Data Sheet
Models Number 5231JA2002A-S
Use with replacement cartridge 5231JA2002A
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration less than
or equal to the permissible limit for water leaving the system as specified in NSF/ANSI 42.
System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction
of Chlorine Taste and Odor and Nominal Particulate Class III.
Capacity: 500 gal (1,892 L)
Substance
Average
Influent
Concentration
Influent Challenge
Concentration.
Units apply to
each row
Avg. Product
Water
Concentration
Average
%
Reduction
NSF % reduction
req. or Max
permissible
product water
concentration
Nominal Particulate
Class I Particle size: ›0.5 to ‹1 um
24,333
At least 10,000
particles/ml
915 96 ≥ 85%
Chlorine taste and odor
Class III
1,9 2.0 mg/L ± 10% 0,07 96,4 ≥ 50%
Note that while the testing was performed under standard laboratory conditions, actual performance may vary.
Application Guidelines / Water Supply Parameters
Service flow 0,5 gpm (1,89 lpm)
Water pressure 20 - 125 psi (138 - 862 kPa)
Water temperature 33 ºF - 100 ºF (0,6 ºC - 38 ºC)
WARNING
To reduce the risk associated with ingestion of
contaminants due to use with water that is micro
biologically unsafe or of unknown quality. Do not
use with water that is micro biologically unsafe or of
unknown quality without adequate disinfection before
or after the system.
Systems must be installed and operated in accordance
with manufacturer’s recommended procedures and
guidelines.
CAUTION
To reduce the risk of property damage due to water
leakage:
• Read and follow Use instructions before installation
and use of this system.
• Install on COLD water lines only. Comply with all
state and local plumbing codes.
• Install a pressure limiting device and water hammer
arrester for inlet water pressures exceeding 80
psi (552 kPa). Refer to Uniform Plumbing Code,
Sections 608.2 and 609.10.
• Never install or operate where inlet water pressure
may exceed 120 psi (827 kPa).
• Protect filter from freezing. Remove filter in
temperatures below 33 °F (0.6 °C).
• Replace cartridge at specified service interval.
Cartridge MUST be replaced at least every 6 months.
To purchase or replace water filters call your Service
Center. Refer to the Warranty Card to obtain the
telephone number of the Service Center near you and
ask for part no. 5231JA2002A or ADQ72910901.
*
Loading ...
Loading ...
Loading ...