Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
34
13. To Remove the Grill Outer Door Panel
Open the left-hand oven door and remove the two screws
from the bottom edge of the grill door.
Open the grill door, support grill door outer panel, and remove
the two screws from the top inner face of the grill door.
Reassemble in reverse order.
14. To Replace the Grill Controller
Disconnect from electricity supply.
Remove the control panel (see 2) and hotplate top (see 3).
Disconnect the wiring from the controller. Remove the two
screws holding the controller to the mounting panel. Fit the
new controller and reassemble in reverse order. Check for
correct operation.
15. To Remove the Grill Element
Disconnect from electricity supply.
Remove grill pan from inside the grill compartment; remove
the enamelled front shield from the grill roof, by undoing the
two screws and washers.
Remove the two screws and washers securing the grill
element front support. Remove the screws from the grill
element.
Lift the element out carefully, disconnecting the leads from
the element terminals (noting their position). If it is not
possible to disconnect the leads in this way, pull the cooker
forward to gain access to the rear, remove the screws securing
the electric cover to the back sheet, remove the cover and
disconnect the terminals from the rear.
Fit the new element and reassemble in reverse order. Check
the operation of the grill.
16. To Replace an Oven Door
Open the oven door. Support the door and remove the two
screws securing the upper hinge and gasket to the cooker
front (Fig.9-6). Remove the door from the lower hinge by
lifting slightly and moving outwards (Fig.9-7).
The door is heavy, so take care.
Reassemble in reverse order.
Note: When replacing the door, make sure that the nylon
hinge bushes are in place in the top and bottom hinge
brackets.
17. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to alter
the angle of the door (Fig.9-8). Loosen the bottom hinge
fixing screws and use the notch and a flat bladed screwdriver
to move the position of the hinge to set the hinge position
(Fig.9-9).
Retighten the hinge screws.
18. To Replace an Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel fixing
screws from the door sides – two each side (Fig.9-10).
Carefully lift off the outer door panel.
Remove the two plastic blanking plugs from the door handle.
ArtNo.320-0006 Oven door hinge adjustment 1
Fig.9-9
Effect of hinge adjustment - exagerrated for clarity
ArtNo.320-0001 Door hinges
�
ArtNo.320-0001 Door hinges
�
Fig.9-6 Fig.9-7
ArtNo.320-0007 Oven door hinge adjustment 2
Fig.9-8
Centreline of hinge pin
Oven door omitted for clarity
�
Fig.9-5
A - Cross support fixing screws
Loading ...
Loading ...
Loading ...