Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
27
Gas Connection
Must be in accordance with the relevant standards.
The gas supply needs to terminate with a down facing
bayonet.
Because the height of the cooker can be adjusted and
each connection is different it is difficult to give precise
dimensions. The hose should be fitted so that both inlet
and outlet connections are vertical so that the hose hangs
downwards in a ‘U’ shape (Fig.7-14).
The connector is located just below the hotplate level at the
rear of the cooker.
A flexible connection is supplied with the cooker. If it is
necessary to use another hose it must be to A.S. 1869 class B
and be suitable for your gas type.
If in doubt contact your supplier. Screw connect the threaded
end of the hose into the gas inlet.
After completing the gas connection, check the cooker is gas
sound with a pressure test.
Pressure Testing
The pressure test point is accessible on the inlet pipe at the
rear. Remove the test nipple screw and fit a pressure gauge to
the test point. Turn on and light two of the hotplate burners.
For Natural Gas cookers the pressure should be 1kPa.
For Propane X cookers the pressure should be 2.54kPa.
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant regulations (AS/NZS
60335.2.6:2002) and also the local electricity supply
company requirements.
Ensure that the mains characteristics (voltage, nominal,
power, etc.) match the ratings indicated on the data plate
affixed to the cooker.
The cooker is preset for a single-phase earthed electrical
connection. It is essential to install a multi-pole circuit breaker
that completely disconnects the appliance from the mains,
with a minimum contact break distance of 3mm.
WARNING: THIS APPLIANCE MUST BE EARTHED
The appliance must be connected to an efficient earthing
circuit. If the electricity network is not equipped with an
earth connection, then it must be installed separately in
compliance with local regulations.
Earthing is a safety measure required by law, and must be
performed with particular care by a qualified technician,
who must also check that the electricity supply
characteristics are correct.
ArtNo.090-0027 - 90 Elan gas connections
�
Fig.7-14
A - Position of gas supply connector, B - Appliance gas inlet
Loading ...
Loading ...
Loading ...