Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
26
ArtNo.070-0011 - Elan bracket holes
Fig.7-13
Fitting the Splashback
The splashback fits the back of the cooker. It is secured using
4 screws (2 at each end) in the rear edge of the flue grille.
Remove the outer 2 screws and then loosen the inner pair. Fit
the splashback over the inner screws and then refit the outer
screws (Fig.7-10). Tighten all screws to secure.
Stability Bracket and Chain
A stability bracket and chain should be fitted when
the cooker is connected to a flexible gas supply.
Unless properly installed, the cooker could be tipped by
leaning on the door. Injury might result from spilled hot
liquids or from the cooker itself.
IMPORTANT: The cooker must be set to the correct height
and levelled before the stability bracket is installed.
Fitting a Stability Bracket (Fig.7-11 and Fig.7-12)
A stability bracket or chain (not supplied by with the
cooker) should be fitted when the cooker is connected to a
flexible gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
1. Place the cooker in its intended position and level the
cooker.
2. Draw a pencil line 100mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4. Lower the front roller and move the cooker forward.
5. Measure back from the pencil line 550mm to locate the
front edge of the bracket. Fix the bracket to the floor.
6. Measure the height from floor level to engagement
edge in back of cooker. Add 3mm to this dimension and
assemble the stability bracket to this height (i.e. from
floor level to underside of the top member) and ensure
the bracket does not foul the oven burner assembly.
Fitting the Restraining Chain
The restraining chain MUST be fitted.
The length of chain between the appliance and the wall fixing
should prevent strain on the gas and electricity connections,
but still allow access to unhook the chain when the cooker is
pull forward.
Fix the supplied hook securely to the wall.
Measure the length of chain required. Use the hexagon-
headed screw, washers and bolt supplied in the restraining
chain kit to fix the chain to one of the holes at the top of the
flue trim bracket (Fig.7-13).
Hook the other end of the chain to the wall fixing.
ArtNo.110-0010 Fitting the stability bracket
Fig.7-11
A - Levelling rollers, B - Levelling feet, C - Wall face,
D - Pencil line on the floor
ArtNo.070-0005 - Stability bracket
Fig.7-12
ArtNo.421-0001 - Fitting a splashback Classic
Fig.7-10
Loading ...
Loading ...
Loading ...