Loading ...
Loading ...
Loading ...
PR3 User’s manual Page
24
FRONT WHEEL REMOVAL
Dismounting and mounting front
wheel
To remove the front wheel, jack the
motorcycle up on its frame so that the
front wheel no longer touches the
ground.
Loosen the 2 clamping screws (1) on
the right side of the fork, hold the wheel
and unscrew the front axle (2). Remove
the front wheel carefully from the fork.
Don’t take spacers (3) off the hub;
these spacers should only be removed
when it is necessary to replace wheel
bearings.
! CAUTION !
- Do not operate hand brake lever
when front wheel has been
removed.
Front wheel mounting
Place front wheel between front fork
sleeves in a way that brake disc is
between brake pads.
Tighten front axle or the fixation nut and
tight fixation screws.
Check if front wheel rotates freely
without any restrain.
Actuate several times front brake lever
until you certify that front brake is
working.
! WARNING !
After mounting front wheel, operate
hand brake lever until pressure
point is established.
Keep brake discs free from oil and
fatty materials; otherwise braking
effect will be strongly reduced.
REAR WHEEL REMOVAL
Dismounting and mounting the rear
wheel
Jack the motorcycle up on its frame so
that the rear wheel no longer touches
the ground. Loosen the collar nut (1) in
the right side, hold the rear wheel and
pull out the wheel spindle (2) by the left
side until the rear wheel is free but the
brake calliper support is still held in the
swing arm.
Push the rear wheel as far forward as
possible, take out the chain from the
rear sprocket and carefully remove the
wheel carefuly from the swing arm.
3
2
1
1
1
2
3
Loading ...
Loading ...
Loading ...