Loading ...
Loading ...
Loading ...
6 7
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
Assembly notes
Before any assembly or installation is attempted it is
important that you check for damage or missing parts.
Your dealer or the manufacturer must be notified of any
problems immediately before proceeding.
The main frame of the barbecue has been factory assembled
requiring only the following simple steps for completion.
Check the “Gas Type “ label attached to barbecue and side
burner to be certain this gas type is the one required for your
use eg. Propane / LPG or Natural Gas. See Fig 5.
Trolleys, roasting hoods and side burners are optional so
read this manual in conjunction with the manual that comes
with each accessory before attaching any other components.
Attach the roasting hood last of all.
Assembly procedure
Heat reflectors, burners and vaporisers
The modular vaporiser grid system has been designed to
maximise the performance of your BeefEater barbecue the
reflectors fit between each burner. They reflect heat from the
burners, upwards to the cooking surfaces.
The vaporizers are designed to vaporise fats and juices from
the meat. One vaporiser is fitted over each burner that is
located under the grill. The vaporisers reduce flare-ups and
help to add that great barbecue flavour.
How many vaporisers and reflectors are there?
MODEL VAPORISER REFLECTOR
2 BNR 2 1
3 BNR 2 2
4 BNR 3 3
5 BNR 3 4
FIG 6
FIG 7
Fitting the heat reflectors
Completely remove all of the plastic film from the reflectors.
The tabbed ends of the heat reflectors face forward to the
front of the barbecue frame. The tabs fit into the slots in the
front end of the barbecue (behind the control fascia). Key
the tabs of the vaporisers into the lower slots (between the
burners). Key the tabs of each reflector into the slots. If slots
are partially covered with enamel, work the tabs until the
enamel clears. See Fig 8.
Fitting the burners
Remove the retaining clips from the burners, then fit the
burners - open end first, over the brass stem of the control
valves at the front of the barbecue, allowing the rear
burner lug to locate into the cross-lighting channel and
corresponding hole in the support panel at the rear or the
barbecue. To secure burners fit retaining clips (“R” shape)
into burner lugs. See Fig 9 & 10.
FIG 8
FIG 9
Upper slots for vaporisers
Lower slots for heat reflectors
Fitting the vaporisers
Remove the protective plastic film from each vaporiser and
then fit the vaporisers to the barbecue. The tabbed ends
of the vaporisers face forward to the front of the barbecue
frame. The tabs fit into the slots in the front end of the
barbecue (behind the control fascia). Key the tabs of the
vaporisers into the upper slots. The vaporisers should be
fitted to the same side of the barbecue to which the grill is
to be placed. (They will not work if fitted under the plate). If
slots are partially covered with enamel, work the tabs until
the enamel clears. See Fig 11 & 12.
FIG 10
FIG 11
Loading ...
Loading ...
Loading ...