Loading ...
Loading ...
Loading ...
143
9
Practical information
301_en_Chap09_info-pratiques_ed01-2016
You can also use the compressor, without
injecting sealant, to check and if necessary
adjust the tyre pressures.
F Check that the compressor switch is at
the "O" position.
F Uncoil fully the electric cable, stowed under
the compressor.
F Connect the compressor's plug to the
vehicle's 12 V socket.
F Switch on the ignition.
F Place the switch in the "O" position.
F Remove the kit.
F Drive immediately for approximately
three miles (five kilometres), at reduced
speed (between 15 and 35 mph (20 and
60 km/h)), to plug the puncture.
F Stop to check the repair and the tyre
pressure using the kit.
Checking / adjusting tyre pressures
F Remove the valve cap from the tyre and
place it in a clean area.
F Uncoil the pipe stowed under the
compressor.
F Screw the pipe onto the valve and tighten
firmly.
Loading ...
Loading ...
Loading ...