Loading ...
Loading ...
Loading ...
14
49-80507-6
INSTALLATION INSTRUCTIONS
Installation Instructions
• When installed, the front face of the warming
drawer will be nearly flush with cabinetry doors or
drawer fronts.
• Drawer overlaps will conceal cut edges on all
sides of the opening.
The rough opening for the drawer must be:
³'HSWK 231/2” minimum from inside back to
front of cabinet frame.
³:LGWK 251/2” for 27” wide models
281/2” for 30” wide models.
³+HLJKW 91/4”
• 5” minimum above floor or 1" above toekick.
231/4” from floor to bottom of cutout is
recommended for under countertop installation.
Installation below a cabinet drawer:
The warming drawer may be installed beneath a
cabinet drawer. In this installation, a solid barrier
should be installed above the warming drawer to
block access. Use any solid material such as 1/4”
thick plywood. Allow at least 1/4” air gap between
the barrier and the top of the warming drawer.
Observe the 5” min. above the floor or 1” above the
toekick min. installation height.
NOTE: If you are installing in frameless cabinets,
it may be necessary to install 1/2” wide cleats to
accept drawer mounting screws. See drawer to find
exact locations of mounting screws.
When installed under a cooktop:
Warming drawers are suitable for installation
below only certain specified cooktop models.
See the label attached to the top of the warming
drawer for suitable models. A solid barrier and
air gap between cooktop and warming drawer is
required. See Note above.
PREPARING CABINET: BELOW A COUNTERTOP
Electrical outlet 42"
max. from right side
1" Min.*
25"
9"
9
1
/4”
23
1
/2” Min.
36"
Countertop
height
Electrical
outlet 16” max.
from left side
Electrical outlet
flush with side of
cabinet 7" max.
Install 2x4 or 2x2
anti-tip block against
rear cabinet wall 9”
from floor to bottom
of block
7"
1
1
/2” Cabinet top
Install a solid barrier
and a 1/4” min. air
gap above warming
drawer
1/4” Air gap
Solid barrier
Install a solid barrier below
a cooktop (see Note)
IN CANADA THIS DRAWER IS NOT
APPROVED FOR INSTALLATION
UNDER A COOKTOP.
*NOTE: When installing the warming drawer below a cooktop, a
solid barrier must be installed at least 1" from the lowest point of
the bottom of cooktop burner box to the top of cutout. Use any
solid material such as 1/4" thick plywood. Allow at least 1/4"air gap
between the barrier and the top of the warming drawer. See label on
top of the wa rming drawer for approved cooktop models.
Dimension A
27" Drawer 30" Drawer
25
1
/2” 28
1
/2”
CAUTION
Loading ...
Loading ...
Loading ...