Loading ...
Loading ...
Loading ...
−−
−
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
FM/AM button. Adjust the volume
by turning the VOL/SELECT knob.
The band and frequency that the
radio was last tuned to are displayed.
To change bands, press the FM/AM
button. On the FM band, ST will be
displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select.
Use the SEEK button to
tune to a desired frequency. Press
the button to tune to a higher
frequency, and the button to
tune to a lower frequency.
You can also operate the tune
function by using the VOL/SELECT
knob. Press the VOL/SELECT knob
and you will see ‘‘SEL’’ in the display.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency. To turn it off, press
the VOL/SELECT knob or
button, or button.
The system will return to the normal
display about 10 seconds after you
stop adjusting the tune mode.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press and hold the or side
of the SEEK button until you hear a
beep, then release it.
The scan function samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When the system finds a strong
signal, it will stop and play that
station for about 10 seconds.
If you do nothing, the system will
then scan for the next strong station
andplayitfor10seconds.Whenit
plays a station you want to listen to,
press the SCAN button again.
CONTINUED
Playing the FM/AM Radio (Models without navigation system)
To Play the FM/AM Radio
To Select a Station
TUNE SEEK
SCAN
Features
167
０８／１２／２７ １１：４７：５８ ３１ＴＭ８６００ ０１７２
2010 Insight
Loading ...
Loading ...
Loading ...