Loading ...
Loading ...
Loading ...
169Driving the vehicle with a trailer
Assembling the ball-headed bar
Fig. 117 Placing the ball-headed bar/locking and removing the key
Fig. 118 Placing the key
slot cover
– Remove the cap from the clamp-type bulb holder
4
⇒ Fig. 114
by pulling downwards.
– Place the ball-headed bar in service position ⇒ page 168.
– Hold the ball-headed bar from underneath ⇒ Fig. 117 and place
it in the clamping bush as far as possible until you hear it click
into place ⇒
.
The manual regulator
A
automatically turns in the opposite direc-
tion, adjusting to the ball-headed bar ⇒
.
– Switch off the manual regulator lock with key
B
by turning the
key fully to the right in the direction of arrow
1
– the arrow in
the key represents the “locked” symbol.
– Remove the key in the direction of arrow
2
.
– Place cover
C
over the manual regulator lock in the direction of
arrow
3
⇒ Fig. 118.
– Verify the correct placement of the ball-headed bar
⇒ page 170.
WARNING
● Do not hold the manual regulator with your hand when fitting the
ball-headed bar since you could sustain injuries to your fingers.
● When mounting the ball-headed bar, always lock it with a key and re-
move the key from the slot.
● The ball-headed bar must not be in service position with the key in
the key slot.
● If the ball-headed bar is not placed in service position you will not be
able to place it in the clamping bush.
CAUTION
When removing the key, always place the cover over the key slot of the man-
ual regulator to prevent dirt from entering.
Note
Once removed, place the clamping bush cap in an appropriate location in
the luggage compartment.
Safety First Operating instructions Practical Tips Technical specifications
Loading ...
Loading ...
Loading ...