Loading ...
Loading ...
Loading ...
Snow Chains
It is possible to fit 13 mm chains on all
the tires except for R20.
Use of traction devices require sufficient
tire-to-body clearance. Follow these
recommendations to guard against
damage.
Note:
Traction device must be of proper
size for the tire, as recommended by the
traction device manufacturer.
Use on Rear Tires Only.
Check the tension of the snow chains
after the first few metres have been
driven.
Using snow chains with tires with
non-original dimensions may damage
the vehicle.
Using different tires sizes or types
(M+S, snow, etc.) between the front and
rear axles may adversely affect vehicle
driveability, with the risk of losing
control of the vehicle and resulting
accidents.
Caution!
To avoid damage to your vehicle or tires,
observe the following precautions:
Because of restricted traction device
clearance between tires and other
suspension components, it is important that
only traction devices in good condition are
used. Broken devices can cause serious
damage. Stop the vehicle immediately if
noise occurs that could indicate device
breakage. Remove the damaged parts of
the device before further use.
Install device as tightly as possible and
then retighten after driving about ½ mile
(0.8 km).
Do not exceed 30 mph (48 km/h).
Drive cautiously and avoid severe turns
and large bumps, especially with a loaded
vehicle.
Do not drive for a prolonged period on dry
pavement.
Observe the traction device
manufacturer’s instructions on the method
of installation, operating speed, and
conditions for use. Always use the
suggested operating speed of the device
manufacturer’s if it is less than 30 mph
(48 km/h).
Do not use traction devices on a compact
spare tire.
Tire Rotation Recommendations
Tires on the front and rear axles of
vehicles operate at different loads and
perform different steering, driving, and
braking functions. For these reasons,
they wear at unequal rates. These effects
can be reduced by timely rotation of
tires. Rotation will increase tread life,
maintain traction levels and contribute to
a smooth, quiet ride.
To resolve this problem, tires should be
rotated at each service interval
(approximately every 10,000 miles
[16,000km]). More frequent rotation is
permissible if desired. The reasons for
any rapid or unusual wear should be
corrected prior to rotation being
performed.
Tire Rotations Not Recommended — If
Equipped
Due to different size tires and wheels on
front and rear axles tire rotation is not
possible for:
2.0T GME Engine Equipped with a
different front and rear tire size.
Caution!
Damage to the vehicle may occur if different
front and rear tire sizes are rotated
244
SERVICING AND MAINTENANCE
Loading ...
Loading ...
Loading ...