Loading ...
Loading ...
Loading ...
JACKING AND TIRE CHANGING
Warning!
Do not attempt to change a tire on the
side of the vehicle close to moving traffic.
Pull far enough off the road to avoid the
danger of being hit when operating the jack
or changing the wheel.
Being under a jacked-up vehicle is
dangerous. The vehicle could slip off the jack
and fall on you. You could be crushed. Never
put any part of your body under a vehicle
that is on a jack. If you need to get under a
raised vehicle, take it to a service center
where it can be raised on a lift.
Never start or run the engine while the
vehicle is on a jack.
The jack is designed to be used as a tool
for changing tires only. The jack should not
be used to lift the vehicle for service
purposes. The vehicle should be jacked on a
firm level surface only. Avoid ice or slippery
areas.
General Instructions
This vehicle can be equipped with a Tire
Service Kit. Refer to “Tire Service Kit” for
further information.
As an alternative to the Tire Service Kit,
the vehicle may be purchased with a
compact spare tire. Refer to “Changing
Procedure” for further information.
Jack Information And Usage
Precautions
Jack Information
The jack weighs 4.4 lb (2 kg).
The jack requires no adjustment.
The jack cannot be repaired, and in the
event of a fault it must be replaced by
another factory replacement.
No tool other than its extension lever
may be fitted on the jack.
Jack Maintenance
Prevent any dirt from depositing on
the "worm screw".
Keep the "worm screw" lubricated.
Never modify the jack.
Conditions Of Non-Use Of The Jack
Temperatures below −40°F (−40°C).
On sandy or muddy ground
On uneven ground
On steep slopes in extreme weather
conditions.
In direct contact with the engine or for
repairs under the vehicle
On boats
Changing Procedure
1. Park the vehicle on a firm, level
surface. Avoid ice or slippery areas.
Warning!
Do not attempt to change a tire on the side
of the vehicle close to moving traffic. Pull far
enough off the road to avoid being hit when
operating the jack or changing the wheel.
2. Turn on the Hazard Warning flasher.
3. Apply the electric park brake.
4. Place the gear selector into PARK.
5. Cycle the ignition to STOP mode.
6.
Block both the front
and rear of the wheel
diagonally opposite of
the jacking position. For
example, if changing the
right front tire, block the
left rear wheel.
7. Open the liftgate and lift up the load
floor using the handle.
8. Take the warning triangle and position
it at a suitable distance from the vehicle
to warn oncoming vehicles.
200
IN CASE OF EMERGENCY
Loading ...
Loading ...
Loading ...