Loading ...
Loading ...
Loading ...
56
Acc ess
Locking
Changing the battery
A message is displayed on the instrument
panel screen when replacement of the battery
is needed.
Version without Keyless Entry and Starting
Battery type: CR1620 / 3 volts.
Version with Keyless Entry and Starting
Battery type: CR2032 / 3 volts.
F Fit the new battery into its housing
observing the polarity.
F Clip the cover onto the casing.
The remote control must be reinitialised after
replacing the battery.
For more information on reinitialising the
remote control, refer to the corresponding
section.
Reinitialising the remote
control
Following replacement of the battery or in
the event of a remote control fault, it may be
necessary to reinitialise the remote control.
Version without Keyless Entry
and Starting
F Open the doors.
F For the rear doors, check that the child lock
is not on.
Refer to the corresponding section.
F Remove the black cap on the edge of the
door, using the key.
F Without forcing, insert the key into the
aperture; then, without turning it, move the
latch sideways towards the inside of the
door.
F Remove the key and refit the black cap.
F Close the doors and check from the outside
that the vehicle is locked.
F Unclip the cover using a small screwdriver
at the cut-out.
F Remove the cover.
F Remove the discharged battery from its
housing.
F Switch off the ignition.
F Turn the key to position 2 (Ignition).
Loading ...
Loading ...
Loading ...