Loading ...
Loading ...
Loading ...
Rinnai Australia 27 Energysaver® - Operation & Installation Manual
The Energysaver
®
Range of heaters has the ability to monitor its own operation continuously. If a fault
occurs, an Error Message will flash on the Digital Display on the control panel. This assists with
diagnosing the fault, and may enable you to overcome a problem without a service call.
Please quote the code displayed when inquiring about service.
Code Displayed Fault Remedy
11
Ignition failure Check gas supply is turned ‘ON’
Turn Heater ‘OFF’ then ‘ON’ again
Service call if repeated
12
Flame failure Check gas is turned ‘ON’
14
Overheat Clean filter
Service call if repeated
16
Room Overheat Lower room temperature to less than 40°C
31
32
Room temperature sensor faulty Service call
33
34
Overheat temperature sensor faulty Service call
53
Sparker failure Service call
61
Combustion fan failure Service call
62
Convection fan failure Service call
70
Faulty ‘ON’/’OFF’ Switch Service call
71
Faulty solenoids Service call
72
Faulty Flame Rod Service call
73
Communication error Service call
In all cases, you may be able to clear the Error Message simply by turning the heater ‘OFF’, then
‘ON’ again. If the Error Message still remains or returns on the next operation, contact Rinnai or your
nearest service agent and arrange for a service call.
Service calls for general cleaning, maintenance and wear and tear are not necessarily
covered under the warranty. Service calls of this nature may be chargeable.
Faults caused by insufficient gas supply, gas quality, installation errors or operation
errors are not covered by the Rinnai warranty. Refer to the Warranty Card for details.
33
11
NOTE
ERROR MESSAGES
Loading ...
Loading ...