Loading ...
Loading ...
Loading ...
Rinnai Australia 26 Energysaver®- Operation & Installation Manual
Before asking for a service call please check the following.
These symptoms are part of the normal operation of the unit and do not indicate a fault.
Symptom Explanation
At Ignition:
Warm air does not start when the burner
lights.
The fan is started automatically after a short delay.
This is to allow the heat exchanger to warm up,
helping to avoid cold draughts.
Smoke or strange smells are produced on
the first trial light up after installation.
This is caused by grease or oil from the
manufacturing process on the heat
exchanger and dust, and will stop after a short time.
Sharp clicking noises at ignition, or when
the unit cuts down on the thermostat, or
goes out.
This is simply expansion noise from the metal heat
exchanger.
During combustion:
Clunking noise when the thermostat
operates.
This is the sound of the solenoid gas valves
opening and closing.
When the unit is turned ‘OFF’:
Convection fan continues to run after
turning ‘OFF’
This is to remove the residual heat from the heat
exchanger. The fan will stop when the unit cools
down.
Other points:
Steam is discharged from the flue terminal. High efficiency appliances tend to discharge water
vapour on cold days. This is normal.
Heater does not start even when ‘ON’
button is pushed and thermostat is on
HIGH.
Check timer. Timer must be in the “OFF” position
for manual operation.
Room temperature is hotter than ‘High’ setting.
Timers:
Timers do not operate at set time. Timers may either be inactivated or incorrectly
programmed. Repeat programming. Refer to
“OPERATING THE TIMERS” on page 11.
Timer operates for 30 seconds then cuts
out.
Room temperature may be higher than set
temperature. Adjust temperature upwards if
desired.
TROUBLE SHOOTING
Loading ...
Loading ...
Loading ...