Loading ...
Loading ...
Loading ...
08 Wheels and tires
Tire Sealing System*
08
306
* Option/accessory, for more information, see Introduction.
Location
Introduction
The vehicle is equipped with a tire sealing
system that enables you to temporarily seal a
hole in the tread surface and re-inflate a flat
tire, or to adjust a tire’s inflation pressure.
The system consists of an air compressor, a
container for the sealing compound, wiring to
connect the system to the vehicle’s electrical
system via one of the 12-volt sockets, and a
hose used to connect the system to the tire’s
inflation valve.
NOTE
The tire sealing system's compressor has
been tested and approved by Volvo.
The 12-volt sockets are located in the front
tunnel console and on the rear side of the
center console in the rear seat, see page 222.
Accessing the tire sealing system
The tire sealing system is stowed under the
floor of the trunk. To access it:
1. Lift the floor hatch in the cargo area.
2. Lift out the tire sealing system.
NOTE
•
The tire sealing system is only
intended to seal holes on the tire’s
tread area, not the sidewall.
•
Tires with large holes or tears cannot
be repaired with the tire sealing sys-
tem.
•
After use, stow the tire sealing system
properly to help prevent rattling.
WARNING
•
After using the tire sealing system, the
vehicle should not be driven farther
than approximately 120 miles (200
km).
•
Have the tire inspected by a trained
and qualified Volvo service technician
as soon as possible to determine if it
can be permanently repaired or must
be replaced.
•
The vehicle should not be driven faster
than 50 mph (80 km/h) while using a
tire that has been temporarily repaired
with the tire sealing system.
•
After using the tire sealing system,
drive carefully and avoid abrupt steer-
ing maneuvers and sudden stops.
Loading ...
Loading ...
Loading ...