Loading ...
Loading ...
Loading ...
66
Setting Up Monitoring Using SNMP
Network administrators can install SNMP (Simple Network Management Protocol) software on network
computers so they can monitor projectors. If your network uses this software, you can set up the
projector for SNMP monitoring.
1. Press the Menu button.
2. Select the Network menu and press Enter.
3. Select Network Configuration and press Enter.
4. Select the Notifications menu and press Enter.
5. Turn on the SNMP setting.
6. Enter up to two IP addresses to receive SNMP notifications, using 0 to 255 for each address field.
Note: To enter the IP address using the numeric keys on the remote control, press and hold the
Num button. Do not use these addresses: 127.x.x.x or 224.0.0.0 through 255.255.255.255 (where x
is a number from 0 to 255).
7. If you want this projector to receive broadcasted messages over the network, select the Others
menu and turn on the Message Broadcasting setting. Administrators can broadcast messages over
the network using Epson Projector Management (Windows only).
8. When you finish selecting settings, select Complete and follow the on-screen instructions to save
your settings and exit the menus.
Loading ...
Loading ...
Loading ...