Loading ...
Loading ...
Loading ...
38
Switching the function off
Place the dial in position 0 or switch off
the ignition to switch everything off.
Cancelling the programmed
reference speed
When the vehicle becomes stationary, after
switching off the ignition, the system no
longer memorises a speed.
Good practice
When changing the programmed reference
speed by means of a maintained press,
pay attention as the speed can increase or
decrease rapidly.
Do not use the cruise control on slippery
roads or in heavy traffic.
In the event of a steep slope, the cruise
control cannot prevent the vehicle from
exceeding the programmed speed.
In any event, the cruise control cannot
replace the need to observe the speed
limits, nor can it replace the need for
vigilance and responsibility on the part of the
driver.
To avoid any jamming under the pedals:
- ensure that the mat is positioned correctly,
- never place one mat on top of another.
Changing the
programmed speed
There are two methods of
memorising a speed higher
than the previous one:
Without using the accelerator:
press the Set + button.
A brief press increases the speed by
1 mph (km/h).
A maintained press increases the speed in
steps of 5 mph (km/h).
Using the accelerator:
exceed the memorised speed until the
speed required is reached,
press the Set + or Set - button.
To memorise a speed lower than the
previous one:
press the Set - button.
A brief press decreases the speed by
1 mph (km/h).
A maintained press decreases the speed
in steps of 5 mph (km/h).
Operating fault
The programmed speed is cleared then
replaced by three dashes.
Contact a PEUGEOT dealer to have the
system checked.
Steering wheel controls
Loading ...
Loading ...
Loading ...