Loading ...
Loading ...
Loading ...
19
Before Installation
Before Installation
■ Do Not Touch the Lens with Bare Hands
Do not touch the lens with bare hands. Doing so may adversely affect picture
quality.
■ Allow a 30 Min. Warm Up before Focus Adjustment (P67), if Possible
The focus position may not stabilize immediately after startup, due to lamp heat.
When adjusting focus, it is also helpful to use the test pattern (10) (P107, P168).
■ Install at a Sufficient Distance from Walls and Other Obstructions
■ Be Careful of Condensation
If the temperature of the room rises suddenly, moisture in the air may condense on
the projector lens and mirror, causing the image to become blurred. Wait until the
condensation has evaporated for the image projected to return to normal.
■ At Altitudes above 2,300 m (7,545.8'), Adjust the Settings
Projector settings must be adjusted when using the projector at altitudes of 2,300 m
(7,545.8') or higher. Specifically, refer to instructions for [High altitude] (P102) in the
[Install settings] menu.
If the air intake or exhaust vent
is blocked, heat will accumulate
inside the projector, possibly
resulting in a shortened
projector lifetime or a
malfunction. Do not install in a
closet, on a bookshelf, or in
other narrow spaces with poor
ventilation. Install in a well-
ventilated location. (Ensure a minimum clearance of 50 cm (1.6 ft.)
above, on both sides, and behind the projector, as shown below.)
Exhaust vent
Air intake vent
50 cm (1.6')
50 cm
(1.6')
50 cm
(1.6')
50 cm
(1.6')
Loading ...
Loading ...
Loading ...