Loading ...
Loading ...
Loading ...
Reference
SQT1112
76
The following messages or service numbers appear on the
front panel display when something unusual is detected.
Selected titles in the USB HDD are being converted.
Do not disconnect the USB HDD from this unit.
TV Guide data is being downloaded.
• The disc is dirty. (> 18) The unit cannot read the disc.
• The lens cleaner has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to eject the disc.
• Displayed when the unit is started and is switched to
standby mode.
• There was a power failure or the AC plug was disconnected
while the unit was on. The unit is carrying out its recovery
process. Wait until the message disappears.
There are already 32 timer programmes. Delete unnecessary
timer programmes. (> 28)
The USB device is drawing too much power. Remove the
USB device.
The remote control and main unit are using different codes.
Change the code on the remote control. (> 71)
Update of the software (firmware) is started. You cannot
operate the unit until the update is complete. (> 59)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or the timer
recording starts. (> 59)
When “FINISH” is displayed, update of the software
(firmware) has completed.
The media is not supported.
The software (firmware) is being updated. You cannot
operate the unit until the update is complete. (> 59)
An error has occurerd in the antenna’s power supply. Check
to see if the antenna’s cable core and braided wire shield are
in contact with each other.
The unit is hot. The unit switches to standby for safety
reasons. Wait for about 30 minutes until the message
disappears.
Install or place this unit with good ventilation.
(When a disc is not inserted) A malfunction has occurred. The
unit is trying to restore to the normal operation. Once the
message disappears you can use the unit again. If it remains
displayed, consult the dealer.
HDMI cannot be output because it is connected to a model
that does not support copyright protection.
Due to the current disc not having authorised copyright
information, video output is not performed.
(When a disc is inserted) There was something unusual
detected with the disc or the unit. The unit is trying to restore
to the normal operation. Once the message disappears you
can use the unit again. If it remains displayed, consult the
dealer.
The unit fails to operate properly. Press [Í/I] on the main unit
to switch the unit to standby mode. Now press [Í/I] on the
main unit again to turn the unit on.
The HOLD function is activated. (> 61)
Messages on the front panel display
CONV
GUIDE
NoREAD
PLEASE WAIT
PROG FULL
REMOVE
SET
(“∑” stands for a number.)
START
SW-DL
UNSUPPORT
UPD /
(“∑” stands for a number.)
U50
U59
U61
U76
U77
U88
U99
XHOLD
DMRPWT560GN_eng.book 76 ページ ２０１６年４月１４日 木曜日 午後１時９分
Loading ...
Loading ...
Loading ...