Loading ...
Loading ...
Loading ...
Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
121
Installing the oven
For safety reasons, the oven may
only be used after it has been fully
installed.
The oven requires a sufficient supply
of cool air for efficient operation. The
required supply of cool air must not
be excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Connect the mains cable from the
oven to the electrical supply.
Use the handle cut-outs on the side of
the housing to lift the appliance.
Remove the door and the accessories
before installing the appliance. This
makes the oven lighter when you push
it into the housing unit.
To remove the door, use the opener
supplied to prise the door open at the
top in the middle. You can also pull
the door open by grasping the sides
of the door with both hands and
pulling carefully until it opens.
Remove the door (see “Cleaning and
care - Removing the door”) and take
the accessories out of the oven.
Push the oven into the housing unit
and align it.
Reconnect the power supply to the
mains socket.
Touch the sensor control to open
the door if you have not removed it
already.
Use the screws supplied to secure
the oven to the side walls of the
housing unit through the holes in the
oven trim.
Refit the door, if necessary (see
“Cleaning and care - Refitting the
door”).
Loading ...
Loading ...
Loading ...