Loading ...
Loading ...
Loading ...
33
INSTALLATION
ENGLISH
Adjusting the Surface Burner to the
Low Flame (Simmer) Setting
•
The continuous simmer setting needs to be
adjusted on all burners.
•
The Extra Low Simmer settings on the small (15K
BTU) burners are adjusted automatically as the
flame cycles off and on.
1
Remove the knob on the burner being adjusted.
2
Unscrew the 2 screws to remove the locking
plate.
Screws for locking plate (2ea)
3
Reassemble the burner knob.
4
Light all surface burners.
5
Turn the knob on the burner being adjusted
to the Simmer or S4 position then remove the
knob.
6
Insert a small, flat-blade screwdriver into
the valve shaft in the left hole and turn the
adjustment screw until the flame reaches the
desired size.
NOTE
Hold the valve shaft with one hand while turning
the screw to adjust with the other.
NOTE
For the center rear burner of Model SKSDR360SS
and SKSDR360SIS, insert the screwdriver into
the valve shaft in the right hole.
7
Reassemble the locking plate and burner knob.
8
Test the flame stability.
Test 1: Quickly turn the knob from the highest
setting to the Simmer or S4 position. If the flame
goes out, increase the flame size and test again.
Test 2: With the burner set to Simmer or S4,
open and close the oven door quickly. If the air
current extinguishes the flame, increase the
flame height and test again.
9
Repeat steps 1-8 for each gas surface burner.
Loading ...
Loading ...
Loading ...