Loading ...
Loading ...
Loading ...
83
More on Photography and Playback
Flash Photography
FLASH FUNCTION SETTING
FLASH FUNCTION SETTING
The following options
are available with the
built-in ash:
MODE
Built-In Flash
ADJUST
END
A
Flash control mode: Choose from the options below.
• A (TTL): TTL mode. Adjust ash compensation (
B
)
and choose a ash mode (
C
).
• B (M): The ash res at the selected output (
B
) regard-
less of subject brightness or camera settings. Output is
expressed in fractions of full power, from / to /. The
desired results may not be achieved at low values if they
exceed the limits of the ash control system; take a test
shot and check the results.
• C (COMMANDER): Choose if the ash is being used to con-
trol remote synced ash units, for example as part of a
studio ash system.
• D (OFF): The ash does not re.
B
Flash compensation/output: Adjust ash level. The options
available vary with the ash control mode (
A
).
C
Flash mode (TTL): Choose a ash mode for TTL ash control.
The options available vary with the shooting mode (P, S, A,
or M) selected.
• E (FLASH AUTO): The ash res only as required; ash lev-
el is adjusted according to subject brightness. A picon
displayed when the shutter button is pressed halfway
indicates that the ash will re when the photo is taken.
•
F (STANDARD): The ash res with every shot if possible;
ash level is adjusted according to subject brightness.
The ash will not re if not fully charged when the shut-
ter is released.
• G (SLOW SYNC.): Combine the ash with slow shutter
speeds when photographing portrait subjects against a
backdrop of night scenery. The ash will not re if not
fully charged when the shutter is released.
D
Sync: Choose whether the ash is timed to re immediately
after the shutter opens (H/1ST CURTAIN) or immediately
before it closes (I/2ND CURTAIN). 1ST CURTAIN is recom-
mended in most circumstances.
Loading ...
Loading ...
Loading ...