Loading ...
Loading ...
Loading ...
(383,1)
北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
1. Set the ignition switch to “ON”.
2. Set the select lever to “R”.
NOTE
. The image of the rear view camera is
horizontally reversed as is the case
with the vehicle inside mirror or the
outside mirror.
. When “Rear Camera Delay Control”
is on, the rear view image will be
displayed on the center information
display for a certain period of time after
the select lever is shifted to a position
other than the “P” position from “R”. To
turn the function on and off, refer to
“General settings” FP216 (11.6-inch
display models) or “General settings”
FP234 (dual 7.0-inch display models).
. It may be difficult to see the image of
the rear view camera in the following
cases. This is not a malfunction of the
camera.
– The vehicle is in a dark place (at
night, in a tunnel, etc.).
– The vehicle is in an extremely hot
or cold place.
– An object (such as raindrops,
snow, dirt, etc.) that disturbs the
view of the rear view camera sticks
to the lens of the camera.
– Strong light is shining directly on
the camera lens (occasionally, there
are vertical lines on the screen).
& Viewing Range on the Screen
s07br02
CAUTION
The range that can be viewed with
the rear view camera is limited.
Always be sure to check with your
eyes when moving backward and
proceed slowly. Otherwise, it may
cause an accident or injury.
Range of view
Range of view
Image from camera
The area from the rear end of the bumper
can be viewed. Areas at both ends of the
bumper and areas just under the bumper
cannot be viewed.
– CONTINUED –
Rear View Camera
381
7
Starting and Operating
Loading ...
Loading ...
Loading ...