Loading ...
Loading ...
Loading ...
Light Charging status
Flashes red Fault in the charging process.
Green Charging process is completed.
When the vehicle is locked, the indicator light
goes out after some time.
When the vehicle is unlocked, the yellow indi‐
cator light flashes continuously. The other indi‐
cator lights go out after some time.
Press the button of the remote control to
check the charging status. The charging status
is indicated on the indicator light. In some
cases the vehicle is locked.
Additional messages about the charging status,
for instance the probable end of charging or
the planned departure time, can be shown in
the instrument cluster or on the Control Dis‐
play.
Planning the charging process
General information
The charging process can be adapted to con‐
straints, for instance the cost of electricity. The
vehicle can control the charging process in such
a way that the charging process is completed at
the departure time. A departure time must be
set for this purpose, refer to page 224.
The following settings are available:
▷ Immediate charging.
▷ Set time window for favorable charging.
▷ Set the charge current for charging via a
Level 1 charging cable.
If drive-ready state is switched off, changes can
be made via the Central Information Display
(CID). Settings for stationary climate control and
charging process are also accepted for planned
departure times.
Immediate charging
The charging process starts as soon as the
charging cable is connected.
Via the Central Information Display (CID):
1. "My MINI"
2. "Plan charging/climate control"
3. "Charge immediately"
Setting time window for favorable
charging
When a departure time is set, a time window
for charging with a favorable electricity rate can
be set via the Central Information Display (CID).
Via the Central Information Display (CID):
1.
"My MINI"
2. "Plan charging/climate control"
3. "Charge for departure time"
4. "Set low cost time slot"
5. Set rate begin.
6. Set rate end.
The vehicle can also start the charging process
before the selected time window begins or end
it after the selected time window finishes. The
starting point of the charging process is ad‐
justed so the vehicle can be fully charged and,
if applicable, its climate controlled right up to
the departure time.
Setting the charge current for charging
via a Level 1 charging cable
Depending on the electrical mains, the vehicle
must be charged with a different charging cur‐
rent strength, refer to page 218.
Via the Central Information Display (CID):
1.
"My MINI"
2. "Plan charging/climate control"
3. "Charging rate settings"
Settings are stored. When you change charging
locations you also might need to change the
setting for charging.
Set the charge current strength at other house‐
hold sockets to the lowest level.
Seite 223
Charging the vehicle
MOBILITY
223
Online Edition for Part no. 01402983594 - X/17
Loading ...
Loading ...
Loading ...