Loading ...
Loading ...
Loading ...
INSTALLATION
Salamander mount w/out shelf
1. Each gas appliance shall be located with respect to building construction and
other Equipment so as to permit access to the appliance. Such access and
clearance may be necessary for service and cleaning.
2. A welded wall mount bracket assembly provided, which includes two (2) hi-
hat supports and a left and right wall, mount bracket.
3. One bottom panel, (4) sheet metal screws and (4) plug buttons
4. Holes required for mounting and hardware for mounting required by others
5. Once the wall mount bracket assembly is in place it is required to support a
minimum of 200 lbs.
6. Before sliding the Salamander in place remove the second screw back from
the front top piece from both the left and right side of the Salamander.
Connect the gas supply and check for gas leaks. DO NOT USE AN OPEN
FLAME.
8. Plug in electrical cord.
9. Slide Salamander to the rear of the assembly until the front of the unit is flush
The wall mounts brackets. Re-install the (2) screws removed from step (7).
10. With the (4) ¼ - 20 bolt provided secure the Salamander to the bottom .
flanges of the Lt./Rt. Wall mount brackets.
11. Secure the bottom panel with (4) sheet metal screws provided an plug the
½” dia. Holes with the (4) plug buttons. Assembly is complete.
WARNING NEVER use this
appliance as a space heater to heat or warm the
room. Doing so may result in carbon monoxide
poisoning and overheating of the oven.
PAGE 10
Loading ...
Loading ...
Loading ...