Loading ...
Loading ...
Loading ...
VD (E3.1) 10/2020 page 145/179
23. Options
23.1 APT-COM™ 4 Multi Management software (Option)
The chamber is regularly equipped with an Ethernet interface (3) that can connect the BINDER APT-
COM™ 4 Multi Management Software.
• RD4 controller: The MAC Address is indicated in the “Ethernet” controller menu (chap. 18.1.1.1).
• MB2 controller: MAC Address is indicated in the “Device info” controller menu (chap. 18.2.1.2).
The actual temperature and pressure values are given at adjustable intervals. Programming can be
performed graphically via PC.
For chambers with RD4 controller, time and week programs can be created and transferred to the
controller, which can then be started and stopped directly from the controller (chap. 14).
Up to 100 chambers can be cross-linked. For further information please refer to the APT-COM™ 4
operating manual.
23.2 Analog outputs for temperature and pressure (option)
With this option, the camber is equipped with analog outputs 4-20 mA for temperature and pressure.
These outputs allow transmitting data to external data registration systems or devices.
The connection is realized as a 9-poles SUB-D socket “Analog output” (10) located in the VD rear control
panel as follows:
ANALOG OUTPUT 4-20 mA DC
PIN 1: Temperature +
PIN 2: Temperature –
PIN 4: Pressure +
PIN 5: Pressure –
Temperature range: 0 °C to +220 °C
Pressure range: 0 mbar to 1100 mbar
A suitable plug is enclosed.
Figure 20: Pin configuration of the SUB-D socket “Analog output” (10) for the analog outputs option
23.3 Measuring access port for vacuum, 9 poles (option)
The measuring access port allows creating electrical connections for low voltages or sensors between the
exterior and interior of the VD vacuum drying oven. A 9 poles plug for the outside is included.
Figure 21: Measuring connection (12) with measuring access
port and supplied plug
Loading ...
Loading ...
Loading ...