Loading ...
Loading ...
Loading ...
||
INSTRUMENTS AND CONTROLS
110
Calibration
The earth is divided into 15 magnetic zones. The
compass is set for the geographic area to which
the car was delivered. The compass should be
calibrated if the car is moved across several mag-
netic zones. Proceed as follows:
1. Stop the car in a large open area free from
steel structures and high-voltage power lines.
2. Start the car.
NOTE
For the best calibration, switch off all electri-
cal equipment (climate control system, wipers,
etc.) and makes sure that all doors are closed.
3. Hold the button on the underside of the rear-
view mirror depressed approx. 3 seconds.
The number of the current magnetic zone is
shown.
Magnetic zones.
4. Press the button repeatedly until the
required magnetic zone (
1–15) is shown.
See the map of magnetic zones for the com-
pass.
5. Wait until the display returns to showing the
character C, or hold the button on the bot-
tom of the rearview mirror depressed for
approx. 6 seconds (use e.g. a paper clip) until
the character C is shown.
6. Drive slowly in a circle at a speed of no more
than 10 km/h (6 mph) until a compass direc-
tion is shown in the display, indicating that
calibration is complete. Then drive a further 2
circles to fine-tune calibration.
7. Repeat the above procedure as necessary.
Menu navigation - combined
instrument panel
The menus shown on the information display in
the combined instrument panel (p. 66) are con-
trolled with the left-hand stalk switch. Which
menus are shown depends on the key position
(p. 81).
Information display (analogue combined instrument
panel) and menu navigation controls.
Loading ...
Loading ...
Loading ...