Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 267
9. Finish tightening the wheel bolts. Push
down on the wrench while at the end of the
handle for increased leverage. Tighten the
wheel bolts in a star pattern until each
wheel bolt has been tightened twice. If in
doubt about the correct tightness, have
them checked with a torque wrench by an
authorized dealer or at a service station
Ú page 335.
10. Push out the small center cap using the jack
tool from inside the aluminum road wheel
and position the wheel behind the rear
fascia/bumper with the protective plate
facing outward.
Installing Protective Plate On Damaged Wheel
NOTE:
The plastic plate will prevent the road wheel
from being scratched when sliding it under the
vehicle.
11. Insert the two long tubes on the plastic
protective plate in the lug holes of the road
wheel. Push the end of the winch’s cable,
spring, steel sleeve and stamped cone
shape wheel plate though the road wheel
and protective plate.
Installing Winch
12. Slide the road wheel on the ground using
the protective plate until it is directly under
the winch and between the rear fascia/
bumper and exhaust system heat shields.
Raise the tire by turning the lug wrench on
the winch extension clockwise until it
clicks/ratchets three times to make sure
the cable is tight.
Wrench Rotation
Road Wheel Installed In Spare Location
7
21_WD_OM_EN_USC_t.book Page 267
Loading ...
Loading ...
Loading ...