Loading ...
Loading ...
Loading ...
Troubleshooting en
29
Fault Cause and troubleshooting
Remnants of food on tableware. Filters are inserted incorrectly and/or not engaged.
1.
Insert the filters properly.
→"Filter system", Page24
2.
Engage the filters.
Washing programme selected too weak.
▶
Select a more intensive washing programme.
▶
Adjust the sensitivity of the sensors.
Tableware has been precleaned too intensely. The sensors chose a weaker pro-
gramme. Stubborn soiling cannot be entirely removed.
▶
Only remove large remnants of food and do not prerinse tableware.
Tall narrow receptacles in corner areas are not rinsed adequately.
▶
Do not position tall narrow receptacles at too great an angle or in corner
areas.
Top baskets on right and left are not set to same height.
▶
Set the top baskets on the left and right to the same level.
→"Top basket", Page12
Detergent residue in the appli-
ance
Lid of the detergent dispenser is blocked by items of tableware parts and will
not open.
1.
Arrange tableware in the top basket tableware so the tab collecting tray is
not obstructed by tableware.
→"Arrange tableware", Page20
Items of tableware are blocking the dispenser lid.
2.
Do not place tableware or fragrance dispensers in the tablet collecting tray.
The lid of the detergent dispenser is blocked by the tab and will not open.
▶
Position the tab in the detergent dispenser crosswise, not vertically.
Tabs are used in the quick or short programme. Dissolving time of the tab is not
attained.
▶
Select a more intensive Programme or use "Powder detergent" →Page19.
Washing effect and dissolving performance are reduced after a prolonged stor-
age time or detergent is very lumpy.
▶
Change your "detergent" →Page19.
Water marks on plastic parts. Due to laws of physics droplet formation on plastic surfaces is unavoidable.
After drying water marks are visible.
▶
Select a more intensive programme.
▶
Position tableware at an angle.
→"Arrange tableware", Page20
▶
Use rinse aid.
→"Rinse aid", Page18
▶
Set the water softening system higher.
Wipeable or water-soluble coat-
ings are present inside the appli-
ance or on the door.
Detergent substances are deposited there. These coatings cannot generally be
removed with chemicals.
▶
Change your "detergent" →Page19.
▶
Clean the appliance mechanically.
White coating is deposited in the appliance interior.
1.
Set the water softening system correctly.
In most cases you will need to increase the setting.
2.
Change your detergent if required.
Special salt dispenser is not screwed tight.
▶
Screw the special salt dispenser tight.
Stubborn white coatings are
present on tableware, inside the
appliance or the door.
Detergent substances are deposited there. These coatings cannot generally be
removed with chemicals.
▶
Change your "detergent" →Page19.
▶
Clean the appliance mechanically.
Loading ...
Loading ...
Loading ...