Loading ...
Loading ...
Loading ...
Water softening system en
17
3.
Hold programme button A and press re-
peatedly until the display shows H:xx.
4.
Release programme button A and .
a Programme button A flashes and the display shows
H:04.
5.
Press programme button C repeatedly until the right
water hardness has been set.
6.
Press to save the setting.
11.3 Special salt
You can use special salt to soften water.
Adding special salt
If the special salt refill indicator lights up, add special
salt to the dispenser for special salt just before the pro-
gramme starts. The amount of special salt required de-
pends on the water hardness: the higher the water
hardness, the greater the amount of special salt re-
quired.
ATTENTION!
Detergent may damage the water softening system.
▶
Only fill the dispenser of the water softening system
with special dishwasher salt.
Special salt can damage the tub due to corrosion.
▶
To make sure that any special salt that escapes is
washed out of the tub, add the special salt to the
dispenser for special salt immediately before the
programme starts.
1.
Unscrew the lid of the dispenser for special salt and
remove.
2.
On initial start-up: Fill the dispenser right up with wa-
ter.
3.
Note:Only use special salt for dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dispenser.
a
Funnel
1
Fill the dispenser right up with special salt. The wa-
ter in the dispenser is displaced and forced out.
4.
Place the lid back on the dispenser and turn to
close.
11.4 Switching off water softening system
Note:
To avoid damage to the appliance, only switch off the
water softening system in the following cases:
¡ The water hardness is max. 26°E and you are us-
ing combined detergents with salt replacement sub-
stances. According to manufacturers, combined de-
tergents with salt replacement substances can gen-
erally only be used up to a water hardness of 26°E
without adding special salt.
¡ The water hardness is 0 - 8°E. You do not need to
use special salt.
1.
Press .
2.
Hold programme button A and press re-
peatedly until the display shows H:xx.
3.
Release programme button A and .
a Programme button A flashes and the display shows
H:04.
4.
Press programme button C repeatedly until the dis-
play shows H:00.
5.
Press to save the setting.
a The water softening system is switched off and the
salt refill indicator is deactivated.
11.5 Regeneration of the water softening
system
In order to obtain fault-free function of the water soften-
ing system, the appliance performs reheating of the wa-
ter softening system at regular intervals.
Regeneration of the water softening system takes place
before the end of the main rinse cycle in all pro-
grammes. It will increase the run time and consumption
values, e.g. water and electricity.
Overview of consumption values with regeneration the water softening system
Here you can find an overview of the maximum additional running time and consumption values during regeneration
of the water softening system.
You can find the column applicable to your model in the quick reference guide according to its water consumption in
the Eco50° programme.
1
Depending on the appliance specifications
Loading ...
Loading ...
Loading ...