Loading ...
Loading ...
Loading ...
Troubleshooting en
27
Fault Cause and troubleshooting
E:24 lights up. Wastewater hose is blocked or kinked.
1.
Reposition the wastewater hose without kinks.
2.
Remove residues.
Siphon connection is still sealed.
▶
Check the connection to the siphon and open if necessary.
Cover of the wastewater pump is loose.
▶
Secure the cover of the "Wastewater pump " →Page33 so it clicks into po-
sition.
E:25 lights up. Wastewater pump is blocked.
▶
Clean the wastewater pump.
→"Clean wastewater pump", Page33
Cover of the wastewater pump is loose
▶
Secure the cover of the "Wastewater pump " →Page33 so it clicks into po-
sition.
E:27 lights up. Mains voltage is too low.
This is not a fault on the appliance.
1.
Contact an electrician.
2.
Have the mains voltage and electrical installation checked by an electrician.
Another error code appears on
the display.
E:01 to E:30
A technical fault is present.
1.
Press .
2.
Unplug the appliance or switch off the fuse.
3.
Wait at least 2minutes.
4.
Insert the mains plug of the appliance in a socket or switch on the fuse.
5.
Switch the appliance on.
6.
If the problem occurs again:
‒ Press .
‒ Turn off the water tap.
‒ Pull out the mains plug.
‒ Contact "Customer Service" →Page34 and give the error code.
18.3 Washing results
Fault Cause and troubleshooting
Tableware is not dry. No rinse aid used or dosage set too low.
1.
Add "Rinse aid" →Page18.
2.
Set the amount of rinse aid to be dispensed.
Selected programme has no drying phase
▶
Select a programme with drying.
Loading ...
Loading ...
Loading ...